溶解式常溫、干燥機

◆貨品特別 Product features

※兼備不穩定性完全一致的排氣工作壓力和露點

1.汽體吸附塔之較高與內徑經研究結果高精密求算，塔床壓力降小，保障了縮小汽體常溫、干燥劑5秒的相處時期，提供樣品氣的露點條件。

2.30％的空氣干澡劑總流量，使用在補賞空氣干澡劑的自然美老化測試，保持空氣干澡。

3.魔幻蔓延器，狠抓空氣不光滑在干澀劑層，避免溝流不良現象。

※重復氣量耗損需小于14％

1.睿智的機筒的設計，同步保存100％的吸附物水溫，存貯的水溫中用增多粉碎時段的粉碎氣水溫，升高環保設備的解吸力量，致使粉碎更撤底。

2.干和重復利用選取反相平衡方案范文，濕暖空氣穿過干的活性炭吸附劑時效性果最佳。重復利用氣出口商含濕量調整在亞過剩的狀態，使消音器原理器及進氣入口無結水之慮。

3.可據太干機的電腦運行負載電阻需要的調節可再造氣容量，切實保障可再造空氣多次相對穩定，可再造壓差低至臨界值。

※干澡劑適用生命周期長

1.好的機筒長寬高，使氣體根據粗糙劑層的流體密度和時間實現好的環境，有效充分的充分利用粗糙劑的機械性能。

2.合理化的體統配值，在氣浪進行機筒前，經除油加工處理立即快速清理氣浪中內含油量物與重被水污染的物，避開烘干劑層受被水污染的。

※機器用了先進高的質量直流電動及油路分配器閥和可信的全手機可源程序序抑制器，人與機器游戲界面親善，重新接連界面顯示雙塔工程，再循環期現場報道可編，出產修改10min。伐門耐用度將近50萬次姿勢。

※筒節開口處作冷鍍鋅鋼板除銹外理，10年不腐蝕。

※操作使用準確的、特點平衡、操作使用簡單便捷，按裝不能不前提。

※Bend it out on the same has the stable pressure and dew point

1. The height and diameter adsorption tower by the experimental results calculated precisely, tower, ensure the small resistance bed compressed gas desiccant 5 seconds contact time, meet the requirements of the finished product angry dew point.

2.30% of the surplus, desiccant used to compensate for the natural aging, ensure desiccant dry.

3. Large diffuser, ensure uniform through the desiccant air layer, eliminate channel flow phenomenon.

※Bend the gas loss less than 14% renewable

1. Excellent barrel design, save 100% of the adsorption quantity of heat, storage quantity of heat is used to increase the regeneration stage again angry temperature, improve equipment desorption ability, make renewable more thoroughly.

2. Dry and regeneration of the reverse convection scheme, wet air through the dry when the adsorbent best effect. Getting angry export moisture content control in the saturated state, the muffler and exhaust passage without concentrations of condensation.

3. According to the operation of the dryer load demand adjust dosage, ensure again angry for stability, regeneration renewable air pressure low to critical.

※Bend desiccant long service life

1. The right of barrel size, make the gas through the desiccant flow velocity and time of layer be the best, give full play to the desiccant performance.

2. The reasonable system configuration, in the air into the barrel, except by the efficient before oil processing timely removal in the air in content and heavy oil pollutant, avoid desiccant layer contamination.

※The equipment adopts bend novel high quality and pneumatic valve electric and advanced and reliable full electronic programmable controller, friendly interface, automatic continuous display of the twin towers, working cycle, the programmable factory set 10 min. The valve life for 500000 times action.

※Bend the cylinder body wall be cold galvanizing antirust processing, 10 years don't rust.

※Bend action, stable performance, accurate, easy operation and installation with no need of foundation.

◆重要方法基本參數 Main technical parameters